Vertical cycloidal reducer is the most important parts of dosing mixing equipment, the normal work of the reducer decided to stir the normal operation.

1.First of all, in the state of the work of the reducer, we should always observe the movement of the reducer in the work, once found abnormal rotation, should be immediately adjusted. Cycloidal reducer is allowed to operate in the continuous working system, allowing the operation in two directions.Rated speed of the input shaft speed is 1500 r/min(For efficiency reasons, actual speed is 1440-1400r/min),When the input power is greater than 18.5 kWh,We propose to use 960r/min 6 pole motor.
2.The working position of vertical cycloidal reducer had better in a horizontal position,Because of this, it is conducive to the operation of the reducer.The maximum horizontal inclination angle is less than 15 degrees at the time of installation.Other measures should be adopted to ensure adequate lubrication and prevent oil leakage at more than 15°.The output shaft of the reducer can not be affected by the axial force and radial force,when have larger axial force and radial force must take other measures.
3.We should always observe the windows in the gas fuel level and adding oil in time.The time to replace the lubricating oil should be determined according to the workload of the reducer.Every day for more than 10 hours of continuous work, every 3 months to replace the lubricating oil,Every day within 10 hours of intermittent work, every six months to replace a lubricating oil.Has been a long time did not use a blender before running again, must be replaced new lubricant grease.
   In this paper, we mainly talk about the use of vertical cycloidal reducer,I think we should have a new understanding of the knowledge in this area.If you had some difficulties in the process of use,you should immediately communicate with us or call our hotline, Please support our work,thank you.