It is not only to provide sufficient power, but also more accurate calculation of speed ratio, torque and so on.If these designs are not standardized will cause the reducer can not be used and resulting in scrap, then in the end how to select it?
Selection is actually an estimation and calculation for the design of mechanical process, through the calculation of torque and speed ratio, tend to pass through the following steps.

1.The torque calculation and estimation:The first thing to estimate work for the design of the mechanical load,Such as design matches for blender to reducer, then we will estimate the mixing material of material as well as the biggest stir tonnage, to estimate the power of the motor, and then matches, according to the power of the motor speed reducer can narrow the scope of the many, or by precise torque calculation, to calculate the maximum torque, contrast cycloid speed reducer torque table can also calculate the deceleration machine number.
2.Calculation of velocity ratio:The speed ratio calculation is a very important problem, through various calculation to determine the per minute output speed reducer.
Estimation of installation form:This is one of the important a deceleration type pause inside, so usually by visual inspection to estimate, for example reducer for vertical or horizontal, biaxial type or straight league one-piece separately. Generally the same type, speed reducer of vertical horizontal, or biaxial straight league points of price is the same.