News
How to do the non rotation of the gear reducer

    Cycloidal reducer can't work normally after installation,, there are many kinds of installation errors, the machine inside the foreign body, rolling bearing damage, cycloid gear installation errors, needle tooth and tooth set of breakage cause jammed, etc:

How to do the non rotation of the gear reducer


    One, first, in accordance with the drawings, check whether the speed reducer is step by step installation errors: if the installation error, speed reducer can cause the damage of the internal parts after the power supply.
    Second, the machine: the foreign body in it owing to the negligence of installation personnel, forget small parts such as foreign body in the machine, can't work normally cause reducer, can be judged according to the sound of work.
    Three, rolling bearing down bad: there were lots of bearing cycloidal reducer, some bearing through hydraulic equipment can be installed go up, improper installation may result in reducer after installation can't rotate.
    Four, cycloid gear installation errors: cycloidal pinwheel installation is in accordance with the standards of domestic commonly, cycloidal pinwheel more parts on the market at present is domestic, so according to the 180 degrees when installation.