The internal structure of various types of gear reducer is the same, so the disassembly and assembly process is basically the same, and the dismantling of the former should be the first to put the net oil, the vertical reducer must first remove the oil pump.
    1, removing: when removing the first loosen the connecting bolts, decomposition of 4, 10, and then in order to break down 6, 7, 8 and other parts. In the opposite order of assembly.

    2,Assembly, please note the following:
    1) before the assembly all parts cleaned.
    2) of rolling and sliding surface coated with lubricating oil to form a lubricating condition.
    3) two cycloid markers must be staggered 180 degrees.
    4) pay attention to adjust the spring rubber seal in elastic and grease.
    5) assembly after the injection of lubricating oil or grease, oil reaches oil standard horizontal line height. Vertical oil reaches oil standard center line.
    6)used in military rotation speed shaft, the inspection without fault can be empty running, the vertical reducer should check pump operating condition is good, if the normal use.
    7) to decompose the direct connection, in strict accordance with the requirements of the order, the first cut from the motor flange decomposition ban.